Scorpion DIY pre-cut Windshield Guard Jeep Wrangler

Scorpion DIY pre-cut Windshield Guard Jeep Wrangler

$99.95

Scorpion DIY pre-cut Windshield Guard Jeep Wrangler

Scorpion’s WindSHIELD Protection Film is a clear, 88% VLT, tough 2 mil thick film designed to protect your windshield from rocks and road debris. Applied like window tint, it significantly increases your windshield’s impact resistance, reducing the risk of cracks and chips. The WindSHIELD Film also blocks 99.9% of harmful UV rays, safeguarding both your vehicle’s interior and its occupants. Constructed with a nano-composite hard coat, shock-absorbing layer, and ultra-clear adhesive, it maintains excellent visibility. Keep your view clear and your windshield protected with Scorpion’s WindSHIELD Film. Kit includes hard card to squeegee and a knife to trim material if needed.

Ultimate Impact Resistance: Safeguard against rocks and road debris, significantly reducing the risk of your windshield cracking or chipping.
99% UV Rejection: Blocks harmful UV rays, protecting your vehicle's interior and occupants.
Crystal Clear Visibility: Nano-composite hard coat w/ ultra clear adhesive to maintain excellent optical clarity.

Installation Guide

 Tools & Supplies Needed

  • Pre-cut windshield guard

  • Spray bottle with slip solution (water + a few drops of baby shampoo)

  • Squeegee (soft edge recommended)

  • Microfiber towels

  • Hard card or plastic edge wrapped in microfiber

  • Razor blade or utility knife (optional for trimming)

  • Nitrile gloves (optional)

1. Preparation

  • Park in a shaded, dust-free area.

  • Clean the windshield thoroughly — remove bugs, sap, and any dirt. Use glass cleaner and finish with isopropyl alcohol.

  • Wash your hands or wear gloves to prevent fingerprints.

2. Wet the Windshield

  • Spray the entire windshield generously with the slip solution. This prevents the film from sticking too quickly.

3. Remove the Liner

  • Peel the backing off the windshield guard. As you do, spray the adhesive side with slip solution to reduce static and ease placement.

4. Position the Film

  • Lay the wet adhesive side of the guard onto the wet windshield.

  • Align it carefully with the corners and edges of the windshield. The solution will allow you to slide it into place.

5. Squeegee from Center Out

  • Begin squeegeeing from the center outward in overlapping strokes, pushing out air bubbles and excess solution.

  • Re-spray the top of the film if needed to reduce friction and avoid scratching.

6. Detail Edges & Corners

  • Use a wrapped hard card to press down the edges, especially around the molding.

  • If necessary, trim any slight overhangs with a razor blade (carefully).

7. Final Inspection

  • Wipe the surface with a clean microfiber towel.

  • Let the vehicle sit for 12–24 hours without windshield wiper use or heavy rain for best adhesion.

Aftercare Tips

  • Don’t go through a car wash for 48 hours.

  • Avoid using abrasive cleaners.

  • Use a soft microfiber towel to clean the windshield guard.

Reviews